Poly Urethane exhibits the following features:

|  Available in any colour required. See Ral Colour chart

|  Solid contents can be customized for application.

|  Low maintenance

|  Highly resistant to acids & alkalis

|  Highly flexible

|  Long shelf life

   Good UV resistant 


Poly Urethane can be used on the following surfaces:

|  Petrochemical

|  Vessel Linings

|  Chemical Industrial

|  Pipe Lines

|  Steel Structures

|  Exterior surfaces

|  Galvanized Sheeting


Finishes available

|  High Gloss

|  Semi-mat


Application procedures  ( Caution This is a hazards product. Always use  protective glasses, respirators and gloves)

|  Surface preparation is the most critical part of the coating procedure.  The surface preparation will vary according to the initial substrate condition, expected service life and general environment conditions.  Optimum preparation for metals will provide a surface cleaned of all contaminates.  Abrasive blasting is recommended to SA 2 – SA 2.5, with a surface profile of 60 microns.


Primer Required

|  Normally applied over Retek Zinc Primers


Topcoat required

|  Normally None



|  Mixing should be done at temperatures between 3ºc - 30ºc.  The dual pack will contain the correct amount of A-Activator and B-Base.  If smaller amounts are to be mixed, the mix should be strictly kept at 3 Parts A – 1 Part B volume.  Under no circumstances should any solvents be added to the product.  It is advised that only the usable amount should be mixed for application.  When the A-Activator and the B-Base are mixed in a container, it should be stirred for approximately five minutes. 



|  75Microns – 7.2 m² per litre


Free delivery in Gauteng on Tuesdays and Thursdays for orders over R1000.

Standard courier charges apply in all other provinces of South Africa.

Bulk delivery rates are negotiable throughout Africa.

Contact us for more information on: 082 527 2531